![]() Seat the module in the backplane connector can result in error messages.Įjector levers are fully closed and then tighten the two captive installationįigure 4. When they are flush with the module faceplate. Seat the module in the backplane connector. Pressing down, simultaneously close the left and right ejector levers to fully Gap between the module EMI gasket and the module above it. Gently press down and simultaneously close the left and right Press down too forcefully on the levers because they will bend and get damaged. To create a small 0.040 inch (1 mm) gap between the module's EMI gasket and the Positioning the Module in the Chassis SlotĪnd forefinger of each hand, grasp the two ejector levers and gently press down Module ejector levers have both closed to approximately 45 degrees with respectįigure 2. Makes contact with the module or cover plate in the slot above it and the The module into the slot until the EMI gasket along the top edge of the module Modules to be inserted between these slot guides. With the slot guides on each side of the chassis slot.įigure 1. Make sure that you align the sides of the module carrier Module from its shipping packaging and from the antistatic shipping bag.ĮSD damage, handle modules by the carrier edges only. Software release notes for any information on slot or chassis restrictions for Removing the two Phillips pan-head screws from the filler plate. Grounding strap to your wrist and to ground.įor the module and remove the module filler plate covering the selected slot by Making it difficult to install the module. Push adjacent modules toward the open slot, reducing the opening size and Installation screws are loose, the EMI gaskets on the installed modules will To maximize the opening space for the new or replacement module. Installation screws are tightened on all modules installed in the chassis.Įnsure that the EMI gaskets on all of the modules are fully compressed in order Modules between empty slots that contain only module filler plates.Īdequate cable guides installed on the chassis to accept the additional network Transceivers, installed directly on the module ports. If either slot hasĪ blank slot cover (Cisco part number WS-X6K-SLOT-CVR), you need to remove theīlank slot cover and replace it with a switching-module filler plate for NEBSĮnough clearance to accommodate any interface equipment, such as pluggable SLOTBLANK-09 or WS-X6K-SLOT-CVR-E) if either slot is unused. In them or a switching-module filler plate installed (Cisco part numbers To the slot where you are installing the module have either a module installed Installing and Removing Ethernet Switching Modules Installing anĮthernet module illustrations are shown here as examples the same installation Installing and Removing Ethernet Switching Modules.Removing Modules, Transceivers, and Attaching Cables
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |